SDRuno Hack for the Icom 7610
I stumbled upon a SDRuno hack for the Icom 7610. There was a post a while back saying that SDRuno could be used with the Icom 7610. Until lately I hadn’t tried it. You may be surprised at how good...
Ham Radio with K0PIR - Icom 7300 and 7610 SDR Transceivers and now Elecraft!
Icom 7300, Icom 7610, Elecraft K3S, KX2, Windows, MacOS, Raspberry Pi, Digital Modes and Contest Software for Amateur Radio
I stumbled upon a SDRuno hack for the Icom 7610. There was a post a while back saying that SDRuno could be used with the Icom 7610. Until lately I hadn’t tried it. You may be surprised at how good...
Picking up where I left off last time I am using a receiving antenna connected to the RX input of the ICOM 7610. For diversity reception, technically I should be using a vertical antenna for the RX input, however I...
This article and video shows how to use the Icom 7610 RX antenna selection, Dualwatch and Tracking. You’ll need to connect a receiving (RX) antenna to the Icom 7610. In the video, three ways are shown to use a receiving...
What are the best mic gain and compression settings? Using the Icom 7300 and Icom 7610 I have multiple mics to use. Each mic is a little different. I’ll show you how I setup the mic gain and compression on...
JTDX Raspberry Pi 3! Does JTDX work good on a small $40 Raspberry Pi 3? You bet it does. This is not something I thought would work well, but with a few adjustments in the JTDX settings it ran very...
Have you heard of JTDX? It’s similar to WSJT-X and will operate FT8 if you download and use the evaluation version, JTDX v2.0.1-rc135 (as of this writing). So why JTDX? A number of fellow Hams have suggested I do a...
Before you go, please subscribe to our YouTube channel to receive notifications when new videos are uploaded.
Recent Comments